Dr. Nasseh discusses some of the limitations of measuring working length while instrumenting simultaneously in handpieces that connect directly to an apex locator…
Follow up on the original ESR CM protocol, Dr. Nasseh talks about the addition of an extra small finishing file 20/04 as well as a 15/03 Scout file that is Austenitic! (Sharper cutting!) …
Dr. Nasseh discusses how to measure working length using the EndoSequence A.I. …
EndoSyncPlus allows open platform changes to Torque, Angles of cutting, and non-cutting direction in OTR motion along with RPM and other customization functions. These changes can make instruments more or less efficient based on a decision to improve safety vs. efficiency. For more safety, manufacturer settings are recommended, for improved efficiency, you can supercharge your EndoSyncPlus with specific changes to either 1. Decreasing the Non-Cutting Angle, 2. Increasing the Cutting Angle, or 3. Increasing the OTR Torque value.
This combination of one or more can synergistically increase efficiency. But keep in mind, any increase in efficiency comes at the cost of safety; therefore, make the right choice based on your level of expertise and the difficulty level of the tooth. Staying at Dr. Nasseh’s manufacturer settings will be fine for most beginner and intermediate users.…
In this video, Dr. Nasseh shares some of the specific memory settings as it relates to safety and efficiency and makes some clinical recommendations for specific settings…
In this EndoSyncPlus Overview Dr. Nasseh goes over the menu settings and various memory settings on the device and explains how to customize and change some of the settings.…
