Tag Archive: OTR

EndoSyncPlus Q&A

September 1, 2019 12:34 am Published by

Dr. Nasseh tries to clear out some confusing points about OTR and reciprocation in this short video.…

3 ways to improve ESR cutting Efficiency with EndoSyncPlus

August 31, 2019 3:26 pm Published by

EndoSyncPlus allows open platform changes to Torque, Angles of cutting, and non-cutting direction in OTR motion along with RPM and other customization functions. These changes can make instruments more or less efficient based on a decision to improve safety vs. efficiency. For more safety, manufacturer settings are recommended, for improved efficiency, you can supercharge your EndoSyncPlus with specific changes to either 1. Decreasing the Non-Cutting Angle, 2. Increasing the Cutting Angle, or 3. Increasing the OTR Torque value.

This combination of one or more can synergistically increase efficiency. But keep in mind, any increase in efficiency comes at the cost of safety; therefore, make the right choice based on your level of expertise and the difficulty level of the tooth. Staying at Dr. Nasseh’s manufacturer settings will be fine for most beginner and intermediate users.…

EndoSyncPlus Overview Part 3 of 3

August 5, 2019 1:32 am Published by

In this video, Dr. Nasseh shares some of the specific memory settings as it relates to safety and efficiency and makes some clinical recommendations for specific settings…

EndoSyncPlus Overview Part 2 of 3.

August 5, 2019 1:25 am Published by

In this EndoSyncPlus Overview Dr. Nasseh goes over the menu settings and various memory settings on the device and explains how to customize and change some of the settings.…